PUBLICATION ETHICS AND PUBLICATION MALPRACTICE STATEMENT
The ethical policy of Journal Technology in Aeospace is based on the Committee on Publication Ethics (COPE) guidelines and complies with International Committee of journal Editorial Board codes of conduct. Readers, authors, reviewers and editors should follow these ethical policies once working with journal. The ethical policy of journal is liable to determine which of the typical research papers or articles submitted to the journal should be published in the concerned issue.
- The publishing decision is based on the suggestion of the journal's reviewers and editorial board members.
- The ethical policy insisted the Editor-in-Chief, may confer with other editors or reviewers in making the decision.
- The reviewers are necessary to evaluate the research papers based on the submitted content in confidential manner.
- The reviewers also suggest the authors to improve the quality of research paper by their reviewing comments.
- Authors should ensure that their submitted research work is original and has not been published elsewhere in any language.
- Applicable copyright laws and conventions should be followed by the authors.
- Any kind of plagiarism constitutes unethical publishing behavior and is unacceptable.
- For information on this matter in publishing and ethical guidelines please visit http://publicationethics.org.
To ensure authorship for the submitted manuscripts, the contributors should meet the following three conditions:
- Conception and design, acquisition of data, or analysis and interpretation of data has been done by the author.
- Either drafting the article or revising it critically for important intellectual content has been done by the author.
- The final approval of the version to be published has been given by the author. Each contributor should have participated sufficiently in the work to be allowed to take public responsibility for suitable portions of the content.
Study design and ethical approval
Good research should be well justified, well planned, appropriately designed, and ethically approved. To conduct research to a lower standard may constitute misconduct. The authors are responsible for the whole scientific content as well as the accuracy of the bibliographic information.
Data should be appropriately analyzed, but inappropriate analysis does not necessarily amount to misconduct. Fabrication and falsification of data do constitute misconduct.
Conflicts of interest
Conflicts of interest comprise those which may not be fully apparent and which may influence the judgment of author, reviewers, and editors. They have been described as those which, when revealed later, would make a reasonable reader feel misled or deceived. They may be personal, commercial, political, academic or financial. “Financial” interests may include employment, research funding, stock or share ownership, payment for lectures or travel, consultancies and company support for staff.
This journal uses Double-blind peer review, which means that both the reviewer and author identities are concealed from the reviewers, and vice versa, throughout the review process. To facilitate this, authors need to ensure that their manuscripts are prepared in a way that does not give away their identity. Authors have the right to communicate to the editor if they do not wish their manuscript to be reviewed by a particular reviewer because of potential conflicts of interest. No article is rejected unless negative comments are received from at least two reviewers.
Redundant publication occurs when two or more papers, without full cross reference, share the same hypothesis, data, discussion points, or conclusions. In such cases, the manuscript will be rejected.
Plagiarism ranges from the unreferenced use of others published and unpublished ideas, including research grant applications to submission under “new” authorship of a complete paper, sometimes in a different language. It may occur at any stage of planning, research, writing, or publication: it applies to print and electronic versions. All the manuscript submitted to journal are checked by authenticate for possible plagiarism. The authors are expected to check their manuscript for plagiarism before submission.
If plagiarism is detected during peer review, the submission can be rejected. If plagiarism is detected after publication we reserve the right, as necessary, to issue a correction or retract the article. We reserve the right to notify the institutions of authors about the plagiarism that was found before or after publication.
Corrections and retractions
To maintain the integrity of academic record, journal may have to publish correction or retraction of paper published in journal. According to agreed academic community norms, corrections or corrections of published articles are made by publishing an Erratum or Retraction article, without altering the original article in any other way than by adding a prominent connection to the Erratum / Retraction article. The original article remains in the public domain and should be commonly indexed to the subsequent Erratum or Retraction. We may have to delete the material from our website and archive sites in the exceptional event the material is considered to infringe those rights or is defamatory.
It may be necessary for the original author(s) to make minor corrections to published articles by making a comment on the published Article. It will only be acceptable if the modifications do not affect the article's results or conclusions.
Changes to published articles that affect the article's meaning and conclusion but do not invalidate the article in its entirety may be corrected, at the discretion of the editor(s), by publishing an Erratum indexed and linked to the original article. Changes in authorship of published articles are corrected through an Erratum.
If the scientific information in an article is significantly compromised on rare occasions it may be appropriate to retract published articles. In these cases Journal must comply with the COPE guidelines. Retracted papers are indexed and the original article is referred to.